Loonie PerksDeals for Canada
BlogSearch
Product guide

Anycubic ACE 2 Pro Filament Dryer and Multicolour Feeder

Feeder: Anycubic ACE 2 Pro is a filament dryer and multicolour feeding unit listed for select Kobra 3 printers. It combines active drying and sealed storage with four-colour printing, while 8-colour use requires a second unit and an additional accessory.

At a glance

  • The listing claims active drying at 65°C and sealed storage with temperature and humidity sensors.
  • A single unit is described as supporting native 4-colour printing. The stated 8-colour setup uses two units and an 8-in-1 or 2-in-1 accessory.
  • Auto-refill is described as switching to a matching backup spool when filament runs out.
  • The listing specifies compatibility with Kobra 3, Kobra 3 V2, Kobra 3 Max and Kobra 3 Max V2.
Price
$339.99Save 40%

Reference price: $570.00

Price checked: Nov 19, 2026

View offer

Pros and cons

Pros

  • Combines filament drying and sealed storage in a unit intended to feed filament during printing.
  • The stated compatibility list gives owners of the specified Kobra 3 models a clear starting point for checking fit.
  • Auto-refill and filament detection may reduce manual changes and setup when using supported Anycubic filament profiles.

Cons

  • The listed 8-colour configuration requires a second ACE 2 Pro unit and an additional accessory, rather than one unit alone.

Technical specifications

2 specifications
Identity
BrandANYCUBIC
Dimensions and installation
Dimensions listed45D x 35W x 32H centimetres

What to know before buying

  • The listing says cardboard spools are not recommended, and says ACE 2 Pro cannot be used simultaneously with the older-generation ACE Pro. Its listed 8-colour capability depends on pairing two units with an 8-in-1 or 2-in-1 accessory.

Who is it for?

A good fit for

  • Owners of a listed Kobra 3 model seeking combined filament drying, storage and multicolour feeding.
  • Users who expect to use auto-refill with matching backup spools or manage moisture-sensitive filament during printing.

Less suited to

  • Owners of printers outside the four listed compatible Kobra 3 models.
  • Buyers seeking 8-colour printing from a single unit or planning to use cardboard spools.
Anycubic ACE 2 Pro Filament Dryer and Multicolour Feeder · photo 2
Additional product photo 2

Frequently asked questions

Which printers is the ACE 2 Pro listed for?

The listing names the Kobra 3, Kobra 3 V2, Kobra 3 Max and Kobra 3 Max V2. It also says the ACE 2 Pro cannot be used simultaneously with the older-generation ACE Pro.

Does one ACE 2 Pro provide 8-colour printing?

No. The listing describes one unit as native 4-colour, and says 8-colour printing requires two ACE 2 Pro units plus an 8-in-1 or 2-in-1 accessory.

Can it dry filament while printing?

The listing claims active drying at 65°C while printing, alongside sealed storage. These are manufacturer claims, not independently verified performance results.

Are cardboard spools recommended?

No. The listing specifically says cardboard spools are not recommended.

Anycubic ACE 2 Pro Filament Dryer and Multicolour Feeder · photo 3
Additional product photo 3

Alternative options

Product details in Markdown